https://origsvn.digium.com/svn/asterisk/branches/1.4
........
r277625 | tringenbach | 2010-07-16 17:43:39 -0500 (Fri, 16 Jul 2010) | 9 lines
Save and restore AST_FLAG_BRIDGE_HANGUP_DONT on attended transfer.
ast_bridge_call() clears AST_FLAG_BRIDGE_HANGUP_DONT. But during an attended
transfer, ast_bridge_call() is called for a second bridge on the same channel,
and it clears that flag, which still needs to get set for when the original
ast_bridge_call() gets control back and checks it.
Review: https://reviewboard.asterisk.org/r/741
........
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@277657 65c4cc65-6c06-0410-ace0-fbb531ad65f3
https://origsvn.digium.com/svn/asterisk/branches/1.4
........
r277497 | mnicholson | 2010-07-16 16:18:38 -0500 (Fri, 16 Jul 2010) | 4 lines
Default to no udptl error correction so that error correction will be disabled in the event that the remote end indicates that they do not support the error correction mode we requested.
FAX-128
........
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@277530 65c4cc65-6c06-0410-ace0-fbb531ad65f3
Just say the number of seconds (after minutes) rather than doing some incorrect
calculation with respect to minutes.
(closes issue #17498)
Reported by: corruptor
Patches:
holdesecs_bug.diff uploaded by corruptor (license 253)
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@277488 65c4cc65-6c06-0410-ace0-fbb531ad65f3
https://origsvn.digium.com/svn/asterisk/branches/1.4
........
r277419 | rmudgett | 2010-07-16 15:18:54 -0500 (Fri, 16 Jul 2010) | 15 lines
priexclusive in chan_dahdi.conf ignored when reloading dahdi module
During a reload, the priexclusive and outsignalling parameters are not
read in from the config file as intended. Unfortunately, they get set to
defaults as a result. This patch makes sure that they do not get set to
defaults during a reload.
(closes issue #17441)
Reported by: mtryfoss
Patches:
issue17441_v1.4.patch uploaded by rmudgett (license 664)
issue17441_v1.6.2.patch uploaded by rmudgett (license 664)
issue17441_trunk.patch uploaded by rmudgett (license 664)
Tested by: rmudgett
........
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@277467 65c4cc65-6c06-0410-ace0-fbb531ad65f3
https://origsvn.digium.com/svn/asterisk/branches/1.4
........
r277247 | mnicholson | 2010-07-16 12:29:57 -0500 (Fri, 16 Jul 2010) | 4 lines
For pass through DTMF tones, measure the actual duration between the begin and end packets on the wire. If it is detected to be less than AST_MIN_DTMF_DURATION, trigger dtmf emulation.
AST-362
........
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@277250 65c4cc65-6c06-0410-ace0-fbb531ad65f3
https://origsvn.digium.com/svn/asterisk/branches/1.4
........
r277182 | pabelanger | 2010-07-16 13:10:36 -0400 (Fri, 16 Jul 2010) | 8 lines
Total analysis time error with SIP and silence suppression
When using app_amd with SIP providers that have silence
suppression on, the iTotalTime count increases exponentially.
(closes issue #17656)
Reported by: juls
........
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@277183 65c4cc65-6c06-0410-ace0-fbb531ad65f3
Found a unused bag of curly brackets under my table. I always wondered where
they had gone. They where indeed needed in chan_sip.c
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276989 65c4cc65-6c06-0410-ace0-fbb531ad65f3
sip.conf configuration for the channel and for devices.
The Max-Forwards header is used to prevent loops in a SIP network. Each intermediary,
like SIP proxys and SBCs, decrement this counter and detects when it reaches zero,
at which point the SIP request is nicely killed in a SIP-friendly way.
Review: https://reviewboard.asterisk.org/r/778/
Thanks to dvossel for the review and good advice.
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276951 65c4cc65-6c06-0410-ace0-fbb531ad65f3
Related to changes from 276571, I was accidentally testing with a port set in
my configuration causing me to miss this. Also moved the TCP handling as well
to occur before build_peer is called.
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276788 65c4cc65-6c06-0410-ace0-fbb531ad65f3
MWI updates were not being sent if no messages were found in the event cache.
This was corrected since a phone may need to clear its MWI status configured
previously from another mailbox.
Upon module or sip reload, MWI updates could not be sent due to the sipsock
socket not being set early enough in reload_config. The code handling the
descriptor assignment and such has simply been moved before the call to
build_peer.
Issuing a sip reload cleared the IP address of the peer, but skipped checking
the database for registration information. The database is now checked both
for sip reload and actually reloading the module.
If a transmission occurs before the do_monitor thread has started, do not
attempt to send a signal to it.
(closes issue #17398)
Reported by: ip-rob
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276571 65c4cc65-6c06-0410-ace0-fbb531ad65f3
ast_sockaddr_stringiy_fmt (which is call by all ast_sockaddr_stringify* functions)
uses thread-local storage for storing the string that it creates. In cases where
ast_sockaddr_stringify_fmt was being called twice within the same statement, the
result of one call would be overwritten by the result of the other call. This
usually was happening in printf-like statements and was resulting in the same
stringified addressed being printed twice instead of two separate addresses.
I have fixed this by using ast_strdupa on the result of stringify functions if
they are used twice within the same statement. As far as I could tell, there were
no instances where a pointer to the result of such a call were saved anywhere, so
this is the only situation I could see where this error could occur.
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276570 65c4cc65-6c06-0410-ace0-fbb531ad65f3
Unlike most responses, the 200 Ok to a pending INVITE Request is
acknowledged by an ACK Request. If the ACK Request for this Response is not received
the previous behavior was to immediately destroy the dialog and hangup
the channel. Now in an effort to be more RFC compliant, instead of immediately
destroying the dialog during this special case, termination is done with a BYE Request
as the dialog is technically confirmed when the 200 Ok is sent even if the ACK is
never received. The behavior of immediately hanging up the channel remains.
This only affects how dialog termination proceeds for this one special case.
RFC 3261 section 13.3.1.4
"If the server retransmits the 2xx response for 64*T1 seconds without receiving
an ACK, the dialog is confirmed, but the session SHOULD be terminated. This is
accomplished with a BYE, as described in Section 15."
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276439 65c4cc65-6c06-0410-ace0-fbb531ad65f3
Change the documented pgsql schema to use "timestamp" instead of "time",
as the latter is only a time without a date.
Added some missing columns for cel's pgsql schema, and corrected spelling
on some others. Updated cel's uniqueid size to be the same as the cdr.
Added id column to cel's pgsql schema and updated code to allow unknown
columns to get their default value instead of forcing 0 or empty string.
Added microseconds to the timestamp cel logs to pgsql.
Review: https://reviewboard.asterisk.org/r/734
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276349 65c4cc65-6c06-0410-ace0-fbb531ad65f3
The purpose of this patch is to eliminate struct ast_callerid since it has
turned into a miscellaneous collection of various party information.
Eliminate struct ast_callerid and replace it with the following struct
organization:
struct ast_party_name {
char *str;
int char_set;
int presentation;
unsigned char valid;
};
struct ast_party_number {
char *str;
int plan;
int presentation;
unsigned char valid;
};
struct ast_party_subaddress {
char *str;
int type;
unsigned char odd_even_indicator;
unsigned char valid;
};
struct ast_party_id {
struct ast_party_name name;
struct ast_party_number number;
struct ast_party_subaddress subaddress;
char *tag;
};
struct ast_party_dialed {
struct {
char *str;
int plan;
} number;
struct ast_party_subaddress subaddress;
int transit_network_select;
};
struct ast_party_caller {
struct ast_party_id id;
char *ani;
int ani2;
};
The new organization adds some new information as well.
* The party name and number now have their own presentation value that can
be manipulated independently. ISDN supplies the presentation value for
the name and number at different times with the possibility that they
could be different.
* The party name and number now have a valid flag. Before this change the
name or number string could be empty if the presentation were restricted.
Most channel drivers assume that the name or number is then simply not
available instead of indicating that the name or number was restricted.
* The party name now has a character set value. SIP and Q.SIG have the
ability to indicate what character set a name string is using so it could
be presented properly.
* The dialed party now has a numbering plan value that could be useful to
have available.
The various channel drivers will need to be updated to support the new
core features as needed. They have simply been converted to supply
current functionality at this time.
The following items of note were either corrected or enhanced:
* The CONNECTEDLINE() and REDIRECTING() dialplan functions were
consolidated into func_callerid.c to share party id handling code.
* CALLERPRES() is now deprecated because the name and number have their
own presentation values.
* Fixed app_alarmreceiver.c write_metadata(). The workstring[] could
contain garbage. It also can only contain the caller id number so using
ast_callerid_parse() on it is silly. There was also a typo in the
CALLERNAME if test.
* Fixed app_rpt.c using ast_callerid_parse() on the channel's caller id
number string. ast_callerid_parse() alters the given buffer which in this
case is the channel's caller id number string. Then using
ast_shrink_phone_number() could alter it even more.
* Fixed caller ID name and number memory leak in chan_usbradio.c.
* Fixed uninitialized char arrays cid_num[] and cid_name[] in
sig_analog.c.
* Protected access to a caller channel with lock in chan_sip.c.
* Clarified intent of code in app_meetme.c sla_ring_station() and
dial_trunk(). Also made save all caller ID data instead of just the name
and number strings.
* Simplified cdr.c set_one_cid(). It hand coded the ast_callerid_merge()
function.
* Corrected some weirdness with app_privacy.c's use of caller
presentation.
Review: https://reviewboard.asterisk.org/r/702/
git-svn-id: https://origsvn.digium.com/svn/asterisk/trunk@276347 65c4cc65-6c06-0410-ace0-fbb531ad65f3
